¶ Excess chute
An assembly that installed on the back of the printer and it is used to hold the nozzle wiper in place to clean the nozzle and slide the excess filament out of the printer.
¶ Tools
H2.0/H1.5 hex key
¶ Preparation
Disconnect the power cord cable.
¶ Disassembly
¶ Step 1 - Remove the rear panel
Refer to the related content of Rear panel to remove the rear panel.
¶ Step 2 - Remove the excess chute
Unscrew 2 screws with an H1.5 hex key （We later added a screw on the left side, which can be unscrewed with an H2.0 hex key）, and then remove the excess chute.
 |
 |
¶ Assembly
¶ Step 1 - Install the excess chute
Install the excess chute on the printer, pay attention to the limit buckles on both sides of the chute and install them in place, and do not press the cable.
¶ Step 2 - Lock screws
Lock in 2 screws to secure the excess chute. （We later added a screw on the left side, you can lock it with an H2.0 hex key）
|
|
|
¶ Step 3 - Install the rear panel
Refer to the related content of Rear panel to install the rear panel.
¶ How to verify
Check the appearance and confirm that there is no abnormality.