Unboxing video
¶ Step 1: Unboxing and Removing Protective Parts
- Open the cardboard box and remove the foam inserts.
 |
 |
Take out the plastic bag and retrieve the Quick Start Guide from the top cover (please read the Quick Start Guide before proceeding to the next step). Take out the printer and the filament spools and air filter included at the bottom of the box.
 |
 |
¶ Step 2: Remove the glass top cover and the plastic bag protecting the front door glass.
 |
 |
 |
 |
¶ Step 3: Take out the accessory box.
 |
 |
¶ Step 4: Remove the two fixing screws of the AMS and take out the AMS.
 |
 |
 |
 |
 |
 |
¶ Step 5: Remove the front chamber LED protective cover (do not forget this step)
Forgetting to remove the protective cover will result in XY home position errors, leading to print failures and a series of error messages.
 |
 |
¶ Step 6: Remove the four fixing screws of the AMS bracket and take out the bracket.
 |
 |
 |
 |
¶ Step 7: Remove the zip tie, protective cardboard, and tape from the tool head.
 |
 |
 |
 |
¶ Step 8: Remove the three fixing screws of the heatbed.
Open the front glass door and remove the three screws securing the heatbed.
 |
 |
¶ Step 9: Place the build plate.
 |
 |
¶ Step 10: Install the touchscreen
Carefully connect the ribbon cable to the touchscreen. You may need to gently pull the ribbon cable, so handle it with caution to avoid damage. When inserting the ribbon cable, ensure the correct orientation and try to insert it vertically. If you need to remove it, make sure to press the buttons on both sides to release the metal latch.
 |
 |
 |
 |
 |
 |
¶ Step 11: Install the external spool holder and put the glass top cover back in place.
 |
 |
 |
 |
¶ Step 12: Install the AMS.
¶ Remove the protective film from the AMS
¶ Take out the spare PTFE tubes
¶ Place the AMS on top of the printer
¶ Connect the PTFE tubes
 |
 |
¶ Use the 4-pin cable to connect the filament buffer to the printer
 |
 |
¶ Use the 6-pin cable to connect the filament buffer to the AMS
 |
 |
¶ Step 13: Power on the printer, start it up, and complete the initialization process
 |
 |
 |
 |
¶ Step 14: Complete the calibration and remove the foam under the heatbed.
Note: After the calibration is completed, please remember to remove the fixed foam under the heatbed.
 |
 |
¶ Step 15: Place the provided filament into the AMS, and close the AMS cover
 |
 |
