¶ Before printing
¶ 1.Printer and build plate type selection
Verify that the selected printer and build plate type match the actual usage.
¶ 2.Print temperature settings
If using third-party filaments, check if the print temperature and heatbed temperature settings are appropriate.
¶ 3.Cleaning the build plate surface
If the build plate is frequently touched by hands or becomes dirty, it can be cleaned with dishwashing detergent.
For detailed cleaning steps, please refer to this wiki: Print Plate Cleaning Guide.
¶ 4.Special filaments and adhesive application
For filaments like PETG, ABS, PA, and ASA, ensure the build plate is clean and apply glue stick or liquid glue before printing.
¶ 5.Build plate positioning
Ensure the build plate is aligned with the rear limit switch of the heatbed.
 |
 |
¶ After printing
¶ Remove the model from the build plate
After the printing is complete, wait for the build plate to cool down completely before removing the model. Usually, gently bending the build plate will allow the model to fall off naturally.
If the model adheres tightly, you can use a scraper to assist in removing it. For flexible TPU models, a few drops of alcohol on the build plate surface can help with demolding.
After removing the model, clean any residual calibration lines on the outer edge of the build plate and return the build plate to its original position for future use.
¶ End Notes
We hope the detailed guide provided has been helpful and informative.
If this guide does not solve your problem, please submit a technical ticket, we will answer your questions and provide assistance.
If you have any suggestions or feedback on this Wiki, please leave a message in the comment area. Thank you for your support and attention!