¶ AMS lite Rotary and AMS Spool Claw
This article provides guidelines and precautions for the disassembly and assembly of the AMS Spool Claw.
¶ Parts List
| NO. | Name | Image | NO. | Name | Image |
| 1 | AMS Rotary Spool Holder |
|
2 | AMS Spool Claw |
 |
¶ Assembly Part List
None
¶ Screw List
None
¶ Tool List
Flat-tipped tweezers
¶ Safety Warning
IMPORTANT!
It's crucial to disconnet the AMS from the printer before performing any maintenance work on the AMS and its electronics, because leaving the AMS connected while conducting such tasks can cause a short circuit, which can lead to additional electronic damage and safety hazards.
If you have any concerns or questions about following this guide, open a new ticket in our Support Page and we will do our best to respond promptly and provide you with the assistance you need.
¶ Video guide
¶ Disassemble the AMS Spool Claw
¶ Step 1 - Remove the AMS Spool Claw
Use the flat-tipped tweezers to pry the Spool Claws up through the gap on the two sides. Remove the other 2 Spool Claws in the same way.
 |
 |
 |
Note: The Spool Claws are easily damaged, so please avoid prying the claws too hard to prevent damage.
¶ Assemble the AMS Spool Claw
¶ Step 1 - Install the AMS Spool Claw
Pay attention to the direction of installation, and then snap the 3 claws into place in turn.
 |
 |
 |
¶ Verify the functionality
Manually press each Spool Claw to make sure the installation is in place.
¶ Calibration
Not required
¶ End Notes
We hope that the detailed guide we shared with you was helpful and informative.
We want to ensure that you can perform it safely and effectively. If you have any concerns or questions regarding the process described in this article, we encourage you to reach out to our friendly customer service team before starting the operation. Our team is always ready to help you and answer any questions you may have.
Click here to open a new ticket in our Support Page.
We will do our best to respond promptly and provide you with the assistance you need.